If you assigned a password to the POE network in the Alert Commander software, that may be part of your issues.
There really isn't much in the way of customization, and it's DHCP, I just set the connected device IP assigned to static in my router, so each time that MAC address connected it has the same IP. Each camera has a powerline adapter with POE, with the primary adapter as the receiver, and that connects to the router. Here is a download link for the very popular wireshark - select the 32bit or 64bit version according to your Windows version :ĭid you have a password set on the Logitech POE adapters? For its time, this system was pretty much dead simple to install.
#Logitech 700e alert commander software install
So my suggestion (if you haven't already got the camera IP addresses figured out) is to install wireshark and capture the broadcasts that one of the cameras emits as it is powered on. These broadcast packets can be captured by a network sniffer program, and the data studied for useful info. If a device wants to grab a specific IP address, it's common for it to check the slot isn't already occupied.Īnd a switched environment will send the broadcast packets to all active devices, unlike the usual action where a packet is only seen by the destination. When network devices start up, it's common for them to broadcast on the network for lots of reasons, and this is intended not just to provide useful info for other devices on the network, but also to solicit needed responses. It may sound a bit daunting, but it's actually not too bad, with a little help from the forum. If hasn't already managed to sort out the problem for you with the remote support offer - I have a suggestion. Well, that's a terrific set of helpful responses for you to consider.
0 kommentar(er)
